Absima CR-18 PRO Bedienungsanleitung Seite 14

Stick Calibration
This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is required, please
follow these steps:
1. Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way forward, then
turn on the transmitter in calibration mode.
• The R.LED and G.LED will flash twice.
2. Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
• When calibration is completed the R.LED will be off.
3. Trigger calibration: Pull the trigger back then forward as far as it will go.
• When calibration is completed the G.LED will be off.
4. Once calibration is complete press the bind key to save and exit.
Failsafe
This function dictates what the receiver will do in the event that it loses signal from the transmitter, this
includes servo position etc.
Setup:
• Turn on the transmitter and make sure it is connected to the receiver. Hold the control surface
at the desired failsafe position.Press and hold the bind button for 3 seconds, if the G.LED starts
flashing every 2 seconds then setup has been successful. Failsafe is now set and will default to
these values when the receiver looses signal.
Note: The fail-safe function has no default set at the factory and as such must be set manually.If no failsafe setting has
been set, then the receiver will not output anything when signal is lost.
Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.
Make sure to disconnect the receiver power before turning off the transmitter. Failure to do so may
lead to damage or serious injury.
Specifications
Product Name
Channels
Model Type
RF
RF power
2.4GHz system
Distance
Channel Resolution
Low Voltage alarm
Power Input
Temperature Range
Humidity Range
Dimension
Weight
Certificate
FS-MG41
4
Car, Boat
2.4 GHz
Less than 20 dBm
ANT
>150m(ground distance without interfence)
1024
Less than 4.2V
6V DC 1.5AAA (LR03)*4
-10℃—+60℃
20—95%
118mm x 73mm x 145mm
130g
CE, FCC