Renkforce IR-1600 Bedienungsanleitung Seite 50

• „Volume": Set the volume here at which the wake-up function is to be activated (a value from 1 - 32 can
be set).
• „Save": After all settings have been made, choose „Save" and then push the setting wheel or the button
„ " (2) of the IR remote control.
If you do not save the setting, they will be lost when leaving the submenu!
6. Submenu „System Settings"
• „Equaliser": The Internet radio has its own internal equaliser with different pre-set sound patterns, e.g.
for pop or rock music. You can also programme your own settings (trebles and bass settings).
• „Network": You can either start the setup wizard here or make all settings manually.
Usually, it is enough to perform commissioning of the Internet radio via the setup wizard. For
signing on to a „normal" WLAN network, it is enough for the Internet radio to select the name of
the WLAN network (SSID) and enter the WLAN password.
Special network configurations require the corresponding specialist know-how.
• „Time/Date": As described for the setup wizard in chapter 13 c), you can activate automatic setting of
date and time here (and the time zone) or perform manual settings. Furthermore, the automatic change
between summer and winter time can be switched on and off, and the time display format (12h/24h) can
be selected.
• „Language": Set the desired menu language for the entire OSD menu of the Internet radio here.
• „Factory reset": Here, all settings of the Internet radio can be reset to factory settings. This will cause all
saved data to be lost (e.g. WLAN access). After selecting this function, a safety prompt appears, asking
whether the reset is to be performed.
• „Software update": The Internet radio can perform an update of the internal operating software. In the
basic settings, there will be a regular check for whether there is a new software; this can be switched
on and off here in this function. You can also manually check for updates.
• „Setup wizard": This function starts the setup wizard, see chapter 13 c).
• „Info": After selection of this function, the display will show the version number of the software and other
data.
• „Backlight": This permits setting the display brightness in 3 stages separately for regular operation and
standby mode. In the basic setting, the highest level of display brightness is set for regular operation the
lowest one for standby mode.
50