Assembly Of The Mast; Assembly Of The Mast To The Body Of The Boat - Reely Triumph Bedienungsanleitung

e) Installing the Mast
The mast has two parts and must be assembled before installation on the deck of the boat. You can glue the two parts
together firmly (recommended) or leave them pluggable for transport reasons.
Push the sleeve (1) onto the lower part of the mast (2)
up to about its half.
Now push the upper mast (4) with adapter (3) onto the
lower part of the mast firmly.
For reasons of stability, we recommend reinforcing the
plug connection between the two mast parts by adding
a little 5-minute epoxy resin in this work step.
f) Assembly of the Mast to the Body of the Boat
Install the mast to the upper deck at the middle hole of
the mast holder with an M2 screw and M2 nut as shown
in figure 6, item 1.
The nut must be secured against coming loose with a
drop of threadlocker varnish.
Attach the transverse beam (2) of the mainsail (called
a „boom" in sailing) to the mast with an M2 screw and
M2 nut (figure 6, item 3).
This nut also must be secured against coming loose
with a drop of threadlocker varnish.
Hook the rope of the „boom" into the formed part of the
mast base (4) and lock it. Tension the rope with a
tensioner so that the rope pulls the „boom" down slightly.
To be able to control the angle of attack of the mainsail,
the „boom" must be connected to the control line of the
sail winch as shown in figure 7, item 1.
Figure 5
Figure 6
Figure 7
33