Reely Triumph Bedienungsanleitung Seite 31

Attach the „Z" of the linage rod to the rudder linkage
lever (figure 3c, item 1).
Place the rudder linkage lever on the rudder linkage as
shown in figure 3c.
Figure 3c
Figure 3d shows the steering servo (1), linkage rod (2)
and rod connection (3).
Align the rudder, rudder linkage lever and servo linkage
lever (see figure 3d) as shown in figure 3a.
Attach the rudder linage lever to the rudder rods with a
shortened hexagon socket wrench (figure 3c, item 2).
Shorten the linkage rods at the rod connection (figure
3d, item 3) so that the linkage is possible as shown in
figure 3a.
Then close the opening of the rudder linage lever with
Figure 3d
the transparent lid so that the writing can be read from
behind. Please also observe figure 12 in these
operating instructions.
31