cecotec bolero DRESSCODE 121000 STEEL Bedienungsanleitung Seite 35

ENGLISH
Temperature
- The washing temperature can be adjusted by pressing the "Temperature/Mute" button.
- The pre-set temperatures are: Cold / 20 ºC / 30 ºC / 40 ºC / 60 ºC / 90 ºC.
Spinning speed
- The spinning speed can be adjusted by pressing the "Spin/Favourite" button.
- The pre-set speeds are: 0 / 400 / 600 / 800 / 1000 / 1200 / 1400 rpm.
Delay start
1. Select a programme.
2. Press the "Delay Start" button to select the time (from 0 to 24 hours).
3. Press the "Start/Pause'' button to activate the delay start function.
To cancel the function, press the "Delay Start" button before starting the programme until the
display shows 0 h. If the programme has already started, restart the washing machine and
select a new programme.
Pre-Wash
- Additional washing cycle prior to the main one to improve washing performance. Suitable
for clothes that are very dirty.
- Note: detergent must be added to compartment I.
- To select it, press the "Functions" button until the "Prewash" icon lights up.
Extra rinse
- The laundry will undergo an additional water rinse after selecting this function.
- To select it, press the "Functions" button until the "Extra Rinse" icon lights up.
Soiling level (MAXICLEAN)
- Washing time will increase or decrease after selecting this function.
- To select it, press the "MAXICLEAN" button until selecting the appropriate soiling level: low,
medium, or high (the corresponding icon will light up).
Quick Wash
- This function allows to reduce the washing-cycle time (depending on the selected
programme).
- To select this function, press the "Quick Wash" button.
Favourite
- You can save the most frequently used programme.
- After choosing the programme and selecting the desired settings, press the "Spin/
Favourite" button for 3 seconds before starting the washing cycle.
- The default programme is "Cotton".
BOLERO DRESSCODE 121000 STEEL
68
SpaCare
- You can use this function with the following programmes: Cotton, Mix, Bed Linen, and Baby
Care.
- Before the washing cycle, laundry is sterilised by steam in the drum.
- To select this function, press the "SPACARE" button.
Comfort Mode
- If this function is activated, the spinning speed is set to 800 rpm, even if the selected
programme has a higher speed by default. In addition, the control panel sounds are
deactivated.
- To activate this function, press the "Comfort Mode" button.
Child lock
- This function is intended to prevent children from misusing the control panel.
- All buttons will be locked except the On/Off button.
- To activate it, press the "Spin/Favourite" and "Functions" buttons simultaneously for about
3 seconds until you hear a beep. The "Child Lock" icon will light up.
- To deactivate the function, repeat the same process.
Warning:
- When the child lock is activated, the display will alternately show "CL" and the remaining
time of the washing cycle. Pressing any other button will cause the child lock icon to flash
for 3 seconds. When the programme is finished, the display will show "CL" and "END"
alternately for about 10 seconds. Then, the icon will flash for 3 seconds.
- You must deactivate the child lock before selecting a new programme.
Mute Mode
- Select the programme and press the "Temperature/Mute" button for about 3 seconds to
deactivate the control panel sound.
- To activate the sound again, repeat this process.
- The setting will be saved until next restart.
Reload
- This operation can be carried out during the washing process.
- Press the "Start/Pause" button for about 3 seconds to pause the washing cycle, unlock the
door, and put new garments into the drum.
- If the drum is rotating with a large amount of hot water inside, the operation cannot be
carried out for safety reasons (the door will remain locked).
- The following steps must be followed:
1. Wait until the drum stops rolling.
2. Check that the door is unlocked.
ENGLISH
BOLERO DRESSCODE 121000 STEEL
69