Husqvarna PG 830S Bedienungsanweisung Seite 12

12. Attach the tool plate straight (E) on the grinding disc.
13. Turn the tool plate (F) to the right or to the left to lock
the tool plate to the grinding disc.
14. Carefully lift the product to operation position. Use
the handlebar and the support frame for support.
15. Disengage the support frame.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the STOP/RUN switch on the control
panel is set to 0.
4. Connect the dust extractor hose to the product.
5. Engage the support frame. Refer to
disengage the support frame on page 9 .
12
E
F
Do not use the dust
To engage and
6. Hang the dust extractor hose on the suspension
device on the support frame to prevent tension in
the dust extractor hose.
7. Disengage the support frame.
Handle positions
• Operation position of the handle:
• Transport position of the handle:
1253 - 004 - 09.12.2022