Husqvarna PG 830S Bedienungsanweisung Seite 19

• Add a second spring steel spring to make the spring
steel head less flexible.
Drive system for grinding head
The drive system for the grinding head is a closed
system. If you have problems with the drive system
of the grinding head, speak to your Husqvarna service
agent.
To install and remove the grinding head
WARNING:
when the grinding head is removed. Make
sure that the chassis can not fall. It can
cause injury or damage.
1. Put the motor cable (A) in front of the grinding head.
B
2. Push the chassis near the grinding head (B).
3. Put the motor cable through the slot between the
grinding head and the chassis.
1253 - 004 - 09.12.2022
The chassis is not balance
A
4. Push the chassis fully against the grinding head (C).
Make sure that the chassis attaches to the bracket
on the grinding head.
C
5. Install the second bracket (D) on top of the bracket
on the grinding head.
6. Tighten the 2 nuts (E) on each side of the grinding
head.
7. Connect the motor cable to the electrical outlet (F)
on the electrical enclosure.
F
D
G
E
19