Specifications - Stihl HSA 60.0 Gebrauchsanleitung

English
Fault LEDs on the
battery
-
Charging does 1 LED emits
not start when red light.
the battery is
inserted into the
charger.
17.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being The LED fla‐
charged. shes red.

18 Specifications

18.1 STIHL HSA 60.0 Hedge Trim‐
mer
– Approved battery: STIHL AK
– Weight without battery: 3.5 kg
For runtime, see www.stihl.com/battery-life.
18.2 Cutting blades
– Tooth spacing: 34 mm
– Cutting length: 600 mm
– Sharpening angle: 35°
18.3 STIHL AK Battery
– Battery technology: Lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: -10°C to +50°C
18.4 Charger STIHL AL 101
– Rated voltage: see rating plate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: see rating plate
– Permissible temperature range for use and
storage: + 5 °C to + 40 °C
The charging times are indicated at
www.stihl.com/charging-times.
18.5 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
40
Cause
The battery life has
been exceeded.
The battery is too
warm or too cold.
Cause
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
18.6
The K-value for the sound pressure level is
2 dB(A). The K-value for the sound power level is
2 dB(A). K-value for vibration level is 2 m/s².
STIHL recommends wearing ear defenders.
– Sound pressure level L
to EN 62841-4-2: 77 dB(A).
– Sound power level L
EN 62841-4-2: 85 dB(A).
– Vibration level a
EN 62841-4-2
– Control handle: 1.0 m/s². The K value for
– Loop handle: 1.5 m/s².
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
Remedy
► Replace battery.
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
Remedy
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
Sound Values and Vibration
Values
p
measured according to
wA
measured as specified in
hv
the vibration level is 2 m/s².
18 Specifications
measured according
0458-019-9801-A