Previewing Custom Programs; Activating Custom Programs; Updating Custom Programs; Sensing Open Windows - Sygonix 2525295 Bedienungsanleitung

à The display shows 2: and the symbol HOT flashes on the display.
6. Continue programming the second programmable period.
7. Continue programming the other weekdays.
à
After all weekdays are programmed, the symbol HOT continues to flash for 2 minutes.
8. Set temperature and heating power. For details, see
Note:
You can leave the custom programming mode any time by pressing the program button PROG.

11.7.2 Previewing custom programs

After programming a custom program, you can preview or review the program settings.
1. Repeatedly touch the mode selection button MODE until PROG shows on the display.
2. Touch the program button PROG to enter the programming mode.
3. Repeatedly touch the timer button TIMER to cycle through the weekdays and preview the programmed periods.
4. Touch the program button PROG to exit the programming mode.

11.7.3 Activating custom programs

You may be using the heater in different modes on different weekdays. Once you have programmed a custom pro-
gram it is stored in memory and you can activate the program at any time.
Preconditions:
a
The heater is operating.
1. Repeatedly touch the mode selection button MODE until PROG shows on the display.
à
The heater operates in custom mode (custom program) until you change modes or switch the heater off.

11.7.4 Updating custom programs

You can update a custom program without affecting existing settings.
1. Repeatedly touch the mode selection button MODE until PROG shows on the display.
2. Touch the program button PROG to enter the programming mode.
3. Repeatedly touch the timer button TIMER to select the weekday you want to update.
4. Touch the menu button UP to enter the first programmable period.
à The display shows 1: and the symbol HOT flashes on the display.
5. Use the menu buttons UP and DOWN to set the hours of the start time. Save with the button TIMER. Set the
minutes of the start time and save again.
6. Use the menu buttons UP and DOWN to set the hours of the end time. Save with the button TIMER. Set the
minutes of the end time and save again.
à
The display shows 2: and the symbol HOT flashes on the display.
7. Continue programming the second programmable period.
8. Touch the program button PROG to exit the programming mode.

11.8 Sensing open windows

If the open window sensing mode is activated, the heater will sense open windows and stop heating. An open win-
dow is defined as a temperature drop of 5 °C or more over a period of 30 minutes.
Setting room temperature [} 33].
35