Cleaning Indications; Grease Filter Cleaning Indicator; Recirculation Filter Replacement Indicator; Cooking Advice - Novy 1861 Easy Recirculation Bedienungsanleitung

6 CLEANING INDICATIONS

6.1 Grease filter cleaning indicator
The grease filter should be cleaned after 20 hours of cooking.
This is automatically indicated by the appliance.
When the appliance is switched on and the extraction power
is set to 0, the time remaining before cleaning the filter can be
read off from the timer display.
After 20 hours of cooking, GrE 00h will appear on the timer
display.
Grease filter
Grease filter remaining time
Press the zone selection button of the
extractor
Press above the zone selection button of
the extractor
The remaining time is indicated.
Resetting the grease filter indicator
Press the zone selection button of the extractor
Press above the zone selection button of
the extractor
Press 00h for 3 seconds until it changes to 20h
Then press 20h again for 3 seconds to confirm
Follow the cleaning instructions set out in the
chapter Cleaning and Maintenance.
6.2 Recirculation filter replacement indicator
The Monoblock filter should be changed after 450 hours of
cooking. This is automatically indicated by the appliance. After
450 hours of cooking, ChA 00h will appear on the timer display.
Recirculation filter
Grease filter remaining time
Press the zone selection button of the extractor
Press 2x above the zone selection button of
the extractor
The remaining time is indicated.
Resetting the grease filter indicator
Press the zone selection button of the extractor
Press 2x above the zone selection button of
the extractor
Press 00h for 3 seconds until it changes to 450
Then press 450 again for 3 seconds to confirm
Follow the replacement instructions set out in
the chapter Cleaning and Maintenance.

7 COOKING ADVICE

Quality of the pots and pans
Suitable cookware, pots and pans include: steel, enamelled
steel, cast iron, stainless steel with magnetic base, aluminium
with magnetic base (±100mm min). Unsuitable pans include:
aluminium and stainless steel without magnetic base, copper,
brass, ceramics, porcelain. The manufacturers will state
whether their products are suitable for induction.
In order to ensure your pans are suitable:
– Pour a little water in a pan and place it on an induction
cooking zone set to
few seconds.
Display
– Hold a magnet to the base of the pan. The magnet should
stick.
GrE
Some cooking pots hum when they are placed on an induction
xxh
cooking zone. This does not mean the device is faulty, and it
will not affect operation. This noise decreases when you adjust
the power.
20h
Lift the pans up when you want to move them to
avoid stains and scratches.
– As often as possible, prepare meals with the pan lid on.
Dimensions of the cooking pans
The cooking zones can (to a certain extent) automatically
adapt to the diameter of the pan. The base of the pan must
have a minimum diameter (± 9cm) for working with the selected
cooking zone. Place the pan in the middle of the cooking zone
in order to optimise the energy transfer. If the diameter of the
Display
pan is much larger than the zone, this will not result in an
optimal cooking result.
ChA
Only the surface of the pan above the induction coil will then
generate the heat. The rest of the surface that is not above the
xxh
induction coil will receive heat via conduction through the pan
surface.
Therefore, if the pan is much larger than the cooking zone, it
advised to set the cooking zone to a slightly lower level to allow
450h
the heat to be divided up more evenly.
– 53 –
. The water should be hot within a