Main Controls - Elkron MP3040 Benutzerhandbuch

2.5 Basic rules for using the keypad
• In the menus, use the ▲and ▼ buttons to move the cursor to the desired item and press OK to confirm.
• Press ESC to go back to the higher level menu.
• If an incorrect code is entered 10 times in a row, the control panel will block other possible attempts for 90 se-
conds for safety reasons. A tamper alarm is generated after 21 incorrect attempts.
• When entering characters, press the ▼ button to delete the last entered character or press the ▲ button to switch
between upper and lower case characters.
• The use of the alphanumeric buttons is indicated in the table below. Repeatedly press each button to display the
indicated characters cyclically.
Button
1 1 . İ , ; - ! ? # *
2 A B C 2
3 D E F 3
4 G H I 4
5 J K L 5
2.6 Keypad setting
With the keypad in stand-by mode, hold the MENU button pressed for a few seconds to adjust the local parameters of
the keypad. Press the ▼ and ▲ buttons to scroll through the menu items. Use the ◄ and ► buttons to adjust values.
Press ESC to finish.
BUZZER ON-OFF
ADDRESS
DISPLAY CONTRAST
DISPLAY INTENSITY
BACKLIGHTING
LED INTENSITY
LANGUAGE
FW VERSION
TEMPERATURE

2.7 Main controls

Total arming: Enter the user code + ON. If the set code is less than 6 digits, after entering the code, press OK followed
by ON.
Scenario arming: Enter the user code + OK. If the code set is less than 6 digits, after entering the code enter OK
followed by OK again. Select the desired scenario with the ▼ and ▲ keys, then OK. If scenarios have been associated
with individual numerical buttons when configuring the control panel, hold the respective button pressed to activate
the scenarios.
If set during control panel configuration, hold buttons 1, 4, 7 pressed to activate the sending of a fire, emergency or
panic alarm.
Total disarming: Enter the user code + OFF. If the set code is less than 6 digits, after entering the code, press OK
followed by OFF.
Silence alarm: Enter the user code (if less than 6 digits followed by OK). Acoustic signals and voice calls will be inter-
rupted, if the function is programmed on the control panel.
Clearing the alarm memory: The alarm memory (
Clearing the fault/tamper memory: The fault memory (
the system again.
Changing the user code: Enter the user code + MENU. Use the ▼ button to select Settings, then Code Change and
enter the new code + OK. Repeat for confirmation + OK. Press ESC repeatedly. Confirm exit from the menu with OK
and save the data again with OK.
Button
1 . İ , ; - ! ? # *
a b c 2
d e f 3
g h i 4
j k l 5
This activates and adjusts the volume of the integrated buzzer on the keypad.
This displays the address assigned by the system to the keypad.
This is used to adjust the contrast of the display.
This is used to adjust the light intensity of the display.
This adjusts the brightness of the button backlighting.
This adjusts the light intensity of the indicator LEDs.
This selects the language of the display messages.
This displays the firmware version of the keypad.
This adjusts the measured temperature offset.
) is cleared when the system is armed again.
) / tampering memory (
6 M N O 6
7 P Q R S 7
8 T U V 8
9 W X Y Z 9
0 <whitespace> _ 0
m n o 6
p q r s 7
t u v 8
w x y z 9
<whitespace> _ 0
) is cleared by switching on
10