12.5 Define switch-off time
In the "Define switch-off time" menu, you can define whether and
when the device automatically switches off after inactivity. Using
you can select from four different switch-off times (5, 10, 15,
20 min) and continuous operation (∞).
Press the action button
menu using
12.6 Update
If a new update or new parameters are to be installed on the device,
it may be necessary to switch the device into update mode. Available
updates and new parameters for the device are found on our
website at www.mn-net.com/de/nanocolor-device-updates. Detailed
information on installing an update can be found in the corresponding
update instructions.
12.7 Language
You can select various languages for the PF-3. However, language
changes always relate only to the names of the individual parameters
and tests; all other functions and settings are shown using language-
neutral icons. You can select the various languages using
Press the action button
menu using
12.8 Calibration
MACHEREY-NAGEL recommends device calibration at regular
intervals, however at least once annually. To perform a calibration,
press the
After a few seconds, the prompt to insert the calibration cuvette
appears. Insert the cuvette and confirm once again with
the calibration, you can exit the menu using
Ensure that the calibration cuvette used is free of scratches and
clouding. Clean the outside of the cuvette with a soft cotton cloth.
Risk of an incorrect calibration: Do not insert the calibration cuvette
until you have been prompted to do so.
40
, your changes will be discarded.
, your changes will be discarded.
button in this menu to start the calibration process.
Manual Photometer PF-3 EN, 04/2021
to save your changes. If you exit the
to save your changes. If you exit the
NOTE
NOTE
.
/
/
.
. After