In Addition To The Parameter Designation, Visocolor - MACHEREY-NAGEL PF-3 Handbuch

Malfunction due to defects at the power supply unit and housing: If
the device has an obvious crack in the housing or a damaged power
supply unit, the device should be taken out of service.
Possible hazards upon contact with chemical and biological
substances.
Working with samples, reagents, and the corresponding accessories
is associated with hazards.
When working with the cuvettes, it must be ensured that suitable
protective equipment is worn. Observe the safety data sheet (SDS)
of the test kit used.
Soiling of the cuvette shaft and incorrect measurements: Clean the
cuvettes before each measurement using a lint-free cotton cloth in
order to avoid soiling of the cuvette shaft and incorrect measurements.
Keep the cuvette shaft free of soiling.
The PF-3 can evaluate tests from our VISOCOLOR
programs. There is a manual for the VISOCOLOR
describes the implementation of the tests in pictogram form. This
manual is included in the device case or it can be downloaded from
www.mn-net.com. The implementation of the NANOCOLOR
described in the corresponding package leaflets.

In addition to the parameter designation, VISOCOLOR

NANOCOLOR
of "NANO" or "VISO" and a 4-digit test number which is unique for this
test.
tests are always identified in the device by the addition
®
Manual Photometer PF-3 EN, 04/2021
NOTE
WARNING
NOTE
and NANOCOLOR
®
tests which
®
®
®
tests is
and
®
37