Teac CD-P1120 Bedienungsanleitung Seite 8

Program Playback
● The program playback function allows
you to program up to 20 tunes (tracks)
for playbak in any desired order.
● If more than 16 tunes are entered, the
rest will not be shown on the Music
Calendar display.
Programming required tunes
Example:
To program tunes in the order 5 ∑ 2 ∑
8 in the stop mode.
1. Press the STOP (ª) button.
2. Press the PROGRAM button.
The player enters the program mode.
The PROGRAM indicator lights in the
display.
3. Enter the first program (track 5), using
the ./¯ MUSIC SKIP buttons or
the numeric buttons. The indicators
blink in the display.
4. Press the PROGRAM button again.
Then, the 5th track has been pro-
grammed as program No. 1.
5. Alternately press the
MUSIC SKIP buttons (or numeric but-
tons) and the PROGRAM button to pro-
gram tracks in the order shown in the
example.
Tune No. Program
on disc No.
6. Press the PLAY button.
Programmed playback starts from the
first programmed tune.
● Programming tunes is possible only
when the player is in the stop mode.
● The programmed contents will be held
in memory even after programmed play-
back has been completed or when pro-
grammed playback is stopped by press-
ing the STOP button.
● When the CLEAR button is pressed in
the stop mode, the contents of the pro-
gram are erased.
Adding to the Programmed
Sequence
Press the STOP (ª) button, then CHECK
button until "--" is shown on the TRACK dis-
play. Repeat from step 2.
To Clear the Program Memory
1. During programmed disc play, press the
STOP (ª) button once to return the CD
player to the standby mode.
2. Press the CLEAR button to clear the pro-
gram memory.
● Press the OPEN/CLOSE (ø) button
once, and the program memory will be
cleared.
● The Program memory will also be
cleared if the CD player's power is
switched off.
Repeat Function
The repeat function allows repeat playback
of any single tune (track), the entire disc, or
of any desired portion on the disc designat-
ed by two (start and end) points.
To repeat one tune
Â/¯
(Single repeat mode)
1. Press the 1/ALL button.
The REPEAT and 1 indicators light.
2. Press the numeric buttons correspond-
ing to the required tune.
Programmed
The selected tune is played, then when
tunes
the end of the tune is reached, the play-
er will return to the beginning of the
tune and playback starts again. In this
way, the selected tune will be played
back repeatedly.
– 8 –
To repeat an entire disc
(All repeat mode)
1. Press the 1/ALL button twice.
The REPEAT and ALL indicators light.
2. Press the PLAY (Á) button.
Playback starts and, when the end of
the disc is reached, the player will
return to the beginning of the first tune,
and then playback continues repeated-
ly.
To repeat a designated section
(A-B repeat mode)
1. Press the PLAY (Á) button to start
playback.
2 Designate the point at which playback
should start (point A) by pressing the A-
B button.
The REPEAT and A - indicators light.
Press
3 When the portion at which repeat play-
back should end is reached, press the
A-B button again to designate point B.
The B indicator lights to show that the
A-B repeat function has been activat-
ed.
Light
Press Again
The player automatically returns to
point A and restarts playback. When
play reaches point B, the player returns
to point A and starts playback again,
repeatedly.