Height Adjustment Of The Tripod - Sachtler Soom Handbuch

Manual
Á Pull the locking bolt out to its end stop (1) and turn
it 90° (2). The bolt will turn easily in either direc-
tion.
Á Once in this position, the locking bolt is effectively
blocked (bayonet lock).
Á Adjust the rotating foot piece of the TriSpread arm
in a straight position.
Á Insert the footpiece into the connecting part of the
TriPod. Insert the foot piece, aligning it between
the bolt and the end portion of the bolt housing to
connect to the tripod (2).
Á Turn the locking bolt back until it snaps in place.
Check to ensure that the bolt has snapped back
completely. It is recommended that the hole of the
locking bolt be kept clean. Otherwise, it may be
necessary to press down on the bolt to snap it in
place.
Á To dismantle, pull the locking bolt back out, turn it
90° and remove the TriSpread arm. Release the
lock position afterwards.

3.4 Height adjustment of the TriPod

Á The level bubble on the TriPod´s ring bowl sup-
ports an easy leveling.
Á To fully extend the TriPod, remove the carrying
handle by only pressing it from the TriPod leg
tubes (see also chapter 3.8).
Á In case where the height of the TriPod needs to be
adjusted with a remaining footprint, the length of
the arms of the TriSpread needs to be adjusted
too (as it does with all other tripods with mid-level
spreader).
- 4 -
SOOM