Chauvin Arnoux PEL51 Schnellstartanleitung Seite 8

DEVICE CONFIGURATION
To configure your PEL, select the device in the PEL network.
Open the Configure Device dialogue box by clicking the Configure
or in the Status area.
This dialogue box has several tabs:
General: to give the device a name, set the automatic turn off delay, choose the refreshing of maximum values,
„
lock the device Select key, prevent battery charging on measurement, set a device configuration password,
set date and time, format the SD card, etc.
Communication: options relating to the wifi connection.
„
Measurement: to select the distribution system.
„
Current sensor: to select the transformation ratio of the current sensors and the number of turns, if necessary.
„
Recording: to select recording parameters.
„
Meters: to reset the energy meters to zero.
„
Click OK to load the new configuration into the device.
START A RECORDING (ON / OFF)
To start a recording, do one of the following:
In PEL Transfer: Select the appropriate option in the Recording tab of the Configuration dialogue box.
„
The device can be configured to trigger a recording either at a future date and time, or immediately after completing
the device configuration.
On the device: Press the Select key. The device displays START. Confirm with the
„
blinks.
To stop a recording, do one of the following:
In PEL Transfer: In the menu, select Device > Stop recording
„
On the device: Press the Select key. The device displays STOP. Confirm with the
„
disappears.
VIEWING THE RECORDING
Recorded data can be transferred to the PC in two ways for viewing and for generating reports:
The SD card can be removed from the device and connected to the PC using the supplied SD card reader.
„
Start PEL Transfer, select the Open command in the File menu, point to the ICP file with the desired session
number on the SD card and select Open.
Direct link between the PC and the PEL (wifi). Start PEL Transfer, open a connection to the device, select it (make
„
sure wifi is enabled) in the navigation tree, then select Recorded Sessions.Double click the desired recording
session. Once the download has finished, select the downloaded test and click Open in the Download dialogue box.
In both cases, the session is added to My Open Sessions in the navigation tree. The data can then be displayed.
USER MANUAL
Go to our website to download the user manual for your device:
www.chauvin-arnoux.com
Search with the name of your device. Once the device is found, go to its page. The user manual is on the right. Download it.
11-2021
696353A00 - Ed. 1
icon in the toolbar, in the Device menu
key. The
.
key. The
symbol
symbol