Inhaltsverzeichnis
Werbung
Adjusting the Mask
1. Use the sliders to adjust the top and bottom headgear straps. To adjust while wearing the
mask, grasp one of the sliders in one hand. Grasp the headgear strap fabric in your other
hand. Pull the slider to either the left or right to tighten or loosen. d
Note: The most common mistake is overtightening. If your mask feels tight, loosen the
headgear straps to adjust the fit. The mask should fit loosely and comfortably against your
face. e
Using the Mask
Note: Re-seat the mask by pulling it away from your face and gently setting it back into place.
1. Connect the flexible tubing (included with your CPAP or bi-level device) to the swivel.
2. Turn the therapy device on. Lie down. Breathe normally.
3. Assume different sleeping positions. Move around until comfortable. If there are any
excessive air leaks, make final adjustments. Some air leaking is normal.
5 Mask Care
Cleaning Instructions
Cautions:
• Any deviation from these instructions may impact the performance of the product.
• Do not place the fabric parts into the dryer.
• Do not use bleach, cleaning solutions containing bleach, or cleaning solutions
containing conditioners or moisturizers.
• Do not use alcohol or cleaning solutions containing alcohol on non-fabric mask parts.
Hand wash non-fabric parts daily. Hand wash fabric parts weekly, or as needed.
1. Disassemble the mask (see Disassembly section).
2. Inspect the entire mask for damage or wear (cracking, crazing, tears, damage resulting in
gel exposure, etc.). Discard and replace any components as necessary.
3. Submerge and hand wash the mask components in warm water (80-90°F) with liquid
dishwashing detergent.
Note: Ensure there are no air pockets present inside the mask parts while submerged.
4. Rinse thoroughly.
5. Lay the fabric parts flat or line dry. Make sure the entire mask is dry before use.
d
e
4
Werbung
Inhaltsverzeichnis
