Monthly Maintenance; Machine Storage - Viper WOLF130 Bedienungshandbuch

INSTRUCTION FOR USE
1) When cleaning operation is complete for the day, drain and rinse the recovery tank thoroughly with clean
water.
2) Remove remaining solution from solution tank.
3) Remove vacuum filter and rinse with clean water.
4) Replace filter when dry.
5) Remove and inspect spray jet. If necessary, clean jet.
NOTE: Do not clean jet with a pointed object, as it will damage the jets.
6) Check brush strip & remove any debris or carpet fibers.
7) Check pick-up head-on hand tool and remove any debris or carpet fibers.
8) Clean machine with a nonabrasive cleaner.
9) Inspect power cable for any damage. Replace if necessary.

MONTHLY MAINTENANCE

1) Flush pump & plumbing with an acetic acid solution to dissolve any chemical buildup.
Mixing Instructions:
a) Premix 8 oz. of an acetic acid solution with 1 gallon of water and pour into solution tank.
Turn vacuum / pump switch on.
b) Put floor tool head over floor drain and pull solution trigger for one (1) minute.
c) Turn machine off and allow remaining solution to sit in machine overnight.
d) The following day spray out remaining solution and flush system again with 1 gallon of clean water.
2) Inspect machine for water leaks.
3) Check machine for loose or missing nuts, screw and bolts and replace as necessary.

MACHINE STORAGE

1) Prior to storing the machine, ensure the solution and recovery tanks are clean and empty of any solution.
2) Store machine in upright position in a dry area, with the vacuum hose removed for air circulation.
NOTE: If you are storing the machine in an area which can freeze, be sure both tanks and the solution plumbing are empty of all
water and dry!
ENGLISH
11