Basic Troubleshooting - Viper WOLF130 Bedienungshandbuch

INSTRUCTION FOR USE

BASIC TROUBLESHOOTING

Trouble
Not plugged in to power source
Machine doesn't
Faulty power cable
work
Faulty extension power cable
Building circuit breaker tripped
Vacuum / pump switch not on
Vacuum / pump switch faulty
Solution
Faulty solenoid
pump not
working
Faulty solution pump
Pump overheated
Loose or broken wiring
Vacuum / pump switch not on
Vacuum / pump switch faulty
Vacuum mo-
Vacuum motor thermal overload tripped
tor not work-
ing
Faulty vacuum motor
Worn carbon brushes
Loose or broken wiring
Air leaking around recovery gasket
Vacuum gasket damaged or worn
Loose vacuum hose connections
Poor pick up
Defective vacuum hose
Loose vacuum hose cuffs
Vacuum hose clogged
Solution tank is empty or low
Vacuum / pump switch not on
Dirty or plugged spray tips
Uneven or no
solution spray
Improper spray tip size or spray angle
Worn spray tips
Faulty solution pump
Clogged solution tank filter
Pinched or kinked solution hose
12
Probable causes Remedy
Plug into a grounded outlet
Contact Distributor
Replace with new extension power cable
Reset circuit breaker
Turn on switch
Contact Distributor
Contact Distributor
Contact Distributor
Determine cause and allow 30 minutes for
pump to cool
Contact Distributor
Turn on switch
Contact Distributor
Check for obstruction and allow 30 minutes to
cool
Contact Distributor
Contact Distributor
Contact Distributor
Ensure recovery lid is firmly tightened
Replace gasket
Ensure vacuum hose connections are tight
Replace vacuum hose
Ensure cuffs are secure to the housing
Remove obstruction from vacuum hose
Fill solution tank
Turn on switch
Clean or replace spray tips
Contact Distributor
Contact Distributor
Contact Distributor
Clean or replace filter
Check for obstructions and kinks and reroute or
replace if needed
ENGLISH