AEG WSP 1210 F Gebrauchs- Und Montageanweisung Seite 34

Circuit diagram WSP 1210 - 4810 F
A1: Electronic charging control unit
B1: Brick temperature sensor - charging
E1 - E6: Heating element (storage heater)
F1: Safety temperature limiter
F2: Fuse (250 V / 2 A slow-blow)
K1: Thermal relay
M1 - M3: Fan - discharge
N4: Temperature limiter - charging
N5: Temperature limiter - discharging
R1: Adjuster – charging (selector knob)
V4: Pilot lamp operation emergency
operation
X1: Mains terminal
X2: Terminal
X3: DC terminal 0.91 – 1.43 V
X16: Control signal adapter 4-stage
X17: Output reducer 4-stage
electron. discharge
control unit
electron. charging control unit
DC signal
Charging control signal
Series circuit
100 % P
rated
3/N/PE AC 50 Hz 400 V 3/N/PE AC 50 Hz 400 V
36
Special accessory
not included in delivery scope, mark the respective accessory if installed
A2:
B2:
R2:
S2:
E8:
N2:
N3:
S1:
Note the permissible rating of the room temperature regulator
when installing the supplementary heater (E8)!
AC-signal 230 V
Charging control signal
91,6 % P
83,3 % P
rated rated
3/N/PE AC 50 Hz 400 V
Integr. room temperature regulator 2-position
Integr. room temperature regulator proportional
Electronic discharge control unit
Room temperature sensor discharge
Adjuster discharge (selector knob)
ON/OFF switch room temperature regulator
Supplementary heater
Supplementary heating element
Temperature regulator – supplementary heater
Temperature regulator – supplementary heater
ON/OFF switch – supplementary heater
*
Control circuit
3/N/PE AC 50 Hz 400 V
1/N/PE AC 50 Hz 230 V
when external RT is connected
*
75 % P 100 % P
rated
3/PE AC 50 Hz 400 V 1/N/PE AC 50 Hz 230 V
For the Fitter
rated