Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connect cooling water to the device
The cooling water lines are mounted directly on the thread of the cooling water connections.
os: 3 /Technic al doc umentati on/Flas h C ORIO/CORIO_CD _GESAMT/EC C onfor mity 200F, 201F , 300F, 600F @ 0\mod_1424948046685_0.doc x @ 7948 @ @ 1
14
NOTE
Environmental damages due to leakage in the cooling water
circuit
If there is a leak in the cooling water circuit, oil from the refrigerant cycle can
get in to the cooling water and lead to environmental damages.
•
Observe the legal regulations applicable at the place of operation
•
If there is leakage in the cooling water circuit, shut down the device and
repair the fault.
The device is switched off.
1.
Connect the cooling water line to the cooling water inlet.
2.
Connect the cooling water return to the cooling water
outlet.
3.
Route the line connected to the cooling-water outlet to the
on-site drain or return flow.
Cooling water is connected. After start-up,
check all hose connections for leaks.
Werbung
Inhaltsverzeichnis
