Problems, Causes And Solutions - Zibro P 7000 Gebrauchsanweisung

E

PROBLEMS, CAUSES AND SOLUTIONS

Contact your dealer if you are unable to solve problems with the aid of the
following hints.
PROBLEM
The machine does
not work.
A function has
been selected, but
the machine does
not work.
The machine
provides no or
insufficient
cooling.
The machine
provides no or
insufficient de-
humidification.
F
MAINTENANCE
Switch the machine off with the 'ON/OFF' button
socket before cleaning it. For reasons of safety it is forbidden to use large
quantities of water during cleaning:
Clean the outside with a damp cloth and then dry it off. Do not use alcohol or
cleaning agents.
Clean the air filter ² every two weeks. This must be carried out in the
following manner:
D D
- Remove the grille.
- Remove the charcoal filter from the grille (fig. D).
- Clean the filter and the grille with a diluted solution of detergent.
- Dry the filter and the grille and re-insert them.
Clean and dry the water reservoir ´, and then replace it.
Clean the front (grille) » with a vacuum cleaner.
CAUSE
The plug is not in the
socket.
The water reservoir is full.
The water reservoir is
fitted incorrectly.
Is the timer on?
The temperature is lower
than 15°C.
The air filter is dirty.
There is ice on the surface
of the evaporator.
The air filter is dirty.
SOLUTION
Insert the plug into the
socket.
Empty the water reservoir.
Insert the water reservoir
correctly.
The machine activates at the
set time.
Pull the filter grille open
and check for ice on the
evaporator.
Clean the air filter.
The machine is set to thaw.
The compressor will restart
after thawing.
Clean the air filter.
and remove the plug from the
4
31
P7000 / P9000 2001