Problems, Causes And Solutions - Zibro TIN-327W Gebrauchsanweisung

Cleaning the deodorising filter
Clean the deodorising filter at least once every two weeks.
1
2
3
4
Replacing the deodorising filter
The deodorising filter must be replaced after approximately 1 year. This must be
done when the colour of the filter has faded significantly and it does not return
to its original state after cleaning.
Replacing the air purification filter
The air purification filter must be replaced every 4 months. This must be done
when the filter is dark in colour.
K

PROBLEMS, CAUSES AND SOLUTIONS

If you are unable to solve a problem with the tips listed below, switch the air
conditioner off and contact your dealer or service department.
THE AIR CONDITIONER DOES NOT WORK
THE AIR CONDITIONER COOLS OR HEATS INSUFFICIENTLY.
THE REMOTE CONTROL DOES NOT WORK.
4
54
First remove the air filter, followed by the deodorising filter. Hold the
deodorising filter by the holder. Do not touch the surface of the filter.
Soak the filter and holder in lukewarm water (max. 30° C) for approximately
15 minutes. Add a mild cleaning agent to remove stubborn dirt. Rinse the
filter thoroughly with clean water in order to remove all soap remnants.
Never scrub or use bleach.
Dry the filter in the shade.
Replace the deodorising filter, and then the air filter.
Check that the plug is inserted firmly into the socket and the power supply
has not been disrupted.
Switch the air conditioner back on when the power supply has been re-
established.
The timer has been set to a later time.
The temperature has not been set correctly. Check:
Cooling: the set temperature must be lower than the room temperature.
Heating: the set temperature must be higher than the room temperature.
The air filter is dirty. Check.
The inlet and/or outlet of the exterior unit is/are blocked. Check.
Environmental factors hinder the effective operation of the air conditioner
(e.g. open door, large number of people in the room). Check.
The batteries have not been placed in the holder correctly. Check (pay
attention to the + and – poles).
The batteries are flat. Replace.