Disposal Considerations - Paramondo Inverna 4000 Montageanleitung

ATTENTION!
You must adhere to the following installati-
on instructions!
Compare the information on mains voltage
/ frequency on the type label with those of
the local network before fitting.
The controller must have a minimum swit-
ching time of 0.5 seconds when changing
the direction.
The switches and/or controllers used must
not execute a UP/DOWN command simulta-
neously!
Movable components of motors that are
operated below a height of 2.5 m above
ground must be protected.
The winding shaft must be fitted in a hori-
zontal position! If the fabric is wound askew,
the motor or awning may be damaged.
Installation equipment (junction boxes,
terminals, etc.) must be easy to remove and
accessible and must not be plastered over or
otherwise sealed permanently.
The manufacturer does not assume any
liability for any defects and damages that are
caused by failure to comply with the fitting
and operating instructions (improper fitting,
incorrect operation, etc.).

Disposal considerations

IMPORTANT!
Disposal instructions!
(European Directive 2012/19/EU (WEEE))
Our electrical and elec-
tronic products are mar-
ked with a crossed-out
wheeled garbage can,
which indicates that the-
se products and any bat-
teries they may contain
must be collected sepa-
rately at the end of their
service life and must not
be disposed of together
with normal household waste.
Owners of WEEE from private
households can hand it in at the
collection points of the public
waste management authorities or
at the take-back points set up by
manufacturers or distributors as
defined by the ElektroG. An online
directory of collection and takeback
points can be found here:
http://www.ear-system.de/ ear-direc-
tory/collection-and take-back
centres.jsf
www.paramondo.de
47