Paramondo Inverna 4000 Montageanleitung Seite 43

Transport and storage
The packaging of the awning must be protec-
ted against wet and damp. Soaked packaging
can come loose and cause accidents.
Transport the awning to the place of instal-
lation in the correct direction for fitting to
prevent turning it in small spaces.
If the awning has to be lifted to an elevated
area with the help of ropes, remove it from
the packaging and connect it with hauling
ropes so that it cannot slip out and pull it up
evenly in a horizontal position.
Proceed in the same manner when uninstal-
ling the awning.
The awning must be protected against
penetrating damp when in storage!
Awnings must be stacked and unstacked so
that they do not prove a hazard to persons
due to tipping over or rolling out of position.
Only create storage facilities and stacks
that can securely take the load. Ensure that
the permissible loads of shelves and other
load-bearing components are not excee-
ded.
You must comply with the general goods
storage principles.
Fixing material
The awning is delivered without any
fixing material
The fixing material must be selected by the
fitter to suit the existing fitting base and
reconciled in accordance with the require-
ments of the system and fitting base.
Here, the information on the required
strength classes of screws must be
observed.
The relevant guidelines (ITRS guideline for
the assessment of the product properties
of awnings) and standards (DIN EN 13561;
Awnings - Performance and safety require-
ments), as well as the instructions for the
safe assembly of screw connections (VDI
2230) must be observed!
When using mounting accessories ordered
Safety instructions
separately as mounting accessories we do
not at the same time assume liability for
liability for proper installation.
The installer alone is responsible for ensu-
ring that the fastening material is suitable
for the suitable for the respective mounting
surface and that that the installation is carri-
ed out correctly.
The respective installation instructions of the
of the fastening material must be be obser-
ved!
SERIOUS RISK OF INJURY FROM THE
SPRING-LOADED AWNING COMPO-
NENTS!
Tension ropes and belts are under high
spring tension!
The maximum load capacity of the nonre-
tractable parts is 800 pa.
Test run
Persons must not stand in the moving area
or beneath the awning when it is extended
for the first time. The fixing materials and
consoles must be visually inspected after the
first extension.
Installation
You need the following equipment in order
to guarantee that the awning is properly
fitted, and therefore the optimal functioning
of the finished product:
Cordless screwdriver
• Drill
• Spirit level
• Ropes / belts
• Complete tool kit
• Equipment for working at height (scaf-
folding, ladders, cherry picker, etc.) that
meet the current individual occupational
health and safety standards.
Apply a maximum force of 20 Nm (= 2 kgm)
when tightening all screws used for alumini-
um components.
www.paramondo.de
43