Panasonic ew3036 Bedienungsanleitung Seite 19

EW3036EU_25-45 05.2.17 7:55 PM ページ 36
Alarm function signals high blood pressure
Blood pressure values for both systolic and diastolic readings are determined
and indicated via a three-color LED system as being within normal or
hypertensive ranges based on definitions and classification of blood pressure
levels by the World Health Organization (WHO), and International Society of
Hypertension (ISH). Moreover, when blood pressure is in the high range,
the reading displayed on screen flashes on and off to alert the user.
According to WHO/ISH guidelines, values consistently in excess of 140 mmHg
(Sys.) and/or 90 mmHg (Dia.) are considered to constitute high blood pressure.
Blood
pressure
sign
LED Colors
Orange
Yellow
Green
• Blood pressure readings will flash for approx. 6 seconds
when in the high blood pressure range.
Systolic blood pressure: 140 mmHg and over
Diastolic blood pressure: 90 mmHg and over
(Only when measurement is complete)
When an error occurs during measurement
An E will appear on the display to indicate that measurement
was unsuccessful and should be performed again.
Before performing another measurement, always press the
On/Off and Start button to turn off the device and make sure to
allow a rest period of 5 minutes before staring again.
Please consult your doctor without delay if the blood pressure indicator
repeatedly draws attention to elevated blood pressure values.
SYS
(mmHg)
Hypertension
(Mild, Moderate, Severe)
140
High–Normal
130
Normal
85 90 DIA
(mmHg)
36
Saving and recalling data
Saving Readings
All data is retained even when the batteries go flat or are changed.
If measurements are carried out without first setting the date and time then
"—/— — : — —" will be displayed.
1. The mark will flash after a measurement has
been completed.
Press the Memory/Recall button
2. Memory storage complete
• Readings of up to 90 measurements can be stored in
memory. Readings over the memory capacity will be
recorded over the oldest measurement in memory.
• Readings cannot be saved when a measurement has
been unsuccessful (display of the error mark
blood pressure readings). Readings can be saved,
however, when the E mark is displayed for the pulse
rate.
GB
E for
37