Use And Operation - SCOPREGA TURBO MAX 12V Anleitung

8. USE AND OPERATION

8.1 ACCESSORIES AND POWER CABLES
1. TURBO MAX 12V and TURBO MAX 24V/S versions: the infl ation hose, adapters and
cable with clamps are located inside the carry bag.
2. TURBO MAX KIT 12V and TURBO MAX KIT 24V-EV versions: as they are intended for a
permanent installation, brackets and retaining screws are provided. The power cable is 50 cm
long and is wired with a 100 A connector.
The infl ation hose and valve fi ttings are supplied only upon request.
Adapters for bayonet valves are available as an optional feature (see catalogue).
8.2 CONNECTING THE ACCESSORIES
1. Choose the most suitable adapter for the valve on the object to be infl ated.
During infl ation/defl ation, the valve should be kept open by a suitable adapter.
2. Make sure that the main switch is set to OFF.
3. Connect the infl ation hose according to the operation to be performed:
to infl ate (connect to the OUT outlet), to defl ate (connect to the IN outlet).
4. Insert the adapter into the valve of the object to be infl ated/defl ated.
8.3 TURNING ON THE INFLATOR
1. Connect clamps to battery or, for KIT versions, make sure that the power connectors are
properly assembled
2. Always stretch the electric cable.
3. Set the desired infl ation pressure (value between 175 and 250 mbar).
4. Set the switch to ON. LED B starts fl ashing, indicating battery status (refer to paragraph
Infl ator and Battery Status Monitoring)
5. Press the START switch. LED B shifts from fl ashing to steady, the colour depends on the
battery status
6. When infl ating, the infl ator will stop at the set pressure and LED B will resume fl ashing
7. In the event of an error, the infl ator stops as a protective measure. LED A lights up to
indicate the type of problem (refer to paragraph Infl ator and Battery Status Monitoring).
Once the problem has been fi xed, the infl ator should be restarted by pressing START.
8. To defl ate, connect the hose to the IN outlet and set the pressure setting knob to 175 mbar.
WARNING
In case crocodile clips are used, make sure of the correct polarity (red clamp connected to
battery positive terminal).
Otherwise the infl ator will not start.
14