SCOPREGA TURBO MAX 12V Anleitung Seite 16

10. TROUBLESHOOTING
PROBLEM
The infl ator
does not start
The infl ator
does not
infl ate
10.1 ONLY FOR TURBOMAX KIT 12V and TURBOMAX KIT 24V-EV
ASSEMBLING THE CONNECTOR
1.
Put the lids and the red grommets onto the cable ends (fi g. 1).
After crimping the faston, we recommend you to tin the cable end to the connector to ensure current
fl ow (fi g. 1 - arrow).
2.
Insert the fastons into their seats, checking coupling tooth (fi g. 2) and polarity (fi g. 4).
3.
Insert the grommets and the lids into their seats (fi g. 3).
POWER CABLE
The cable section of the on-board supply system should be suitable for its length:
4.
For cable length up to 6 meters: 10 mm2 section
5.
For cable length from 6 to 12 meters: 16 mm2 section
16
POSSIBLE CAUSE
Power cable not properly
connected.
Undervoltage in battery.
Overvoltage in battery.
The ON button has not been pressed.
The safety fuse is blown.
The device is damaged
Hose wrong connection.
Wrong pressure setting.
Switch not in START position.
POSSIBLE SOLUTION
Connect the power cable correctly
and with the right polarity (red clamp
to battery positive terminal).
Check battery conditions.
Check battery conditions.
Press the ON key.
Replace the fuse with one of the same
type (40 or 70 A).
Contact a SCOPREGA service
centre.
Connect the air hose to the
correct port.
Correct pressure setting.
Set main switches to ON and then
press START.