Kinderkraft I-GUARD Bedienungsanleitung Seite 47

• Place the seat without the cover (19) with the folded-out support leg on the vehicle seat.
• Attach the ISOFIX guides (18) to the car seat connectors (A.4).
• Slide the ISOFIX attachments (16) to their maximum length by unlocking and holding the
sliding lever (12) (fig. A.5a) and then sliding the attachments (fig. A.5b). This has to be done
on both sides of the seat.
• Connect the extended ISOFIX attachments (16) to the ISOFIX guides (18) installed in the car
seat until a characteristic click occurs (fig. A.6). After the correct installation of the ISOFIX
attachments, the indicator on the button (15) will change from red to green; verify the correct
installation with green indicators (fig. A.7a, A.7b).
• ATTENTION! The locking clips are only correctly fastened when both button markers are
completely green.
• When the seat is correctly installed with ISOFIX, position the seat facing forward. Push the
seat rotation lever (7); (fig. A.9) to turn the seat in the direction of travel (fig. A.10b),
a correctly locked position will be indicated by the green colour indicator at the seat rotation
lever (7).
• Make sure the base is fixed by trying to pull it out of the ISOFIX attachment points.
• Push the base with a left-right movement towards the backrest of the vehicle seat until it is
completely aligned with the backrest of the anti-rotation frame (14) (fig. A.8)
• When the seat is correctly installed with the ISOFIX attachments and the base's anti-rotation
frame is fully seated against the backrest of the seat, proceed to adjust the support leg (9).
ATTENTION: Before adjusting the support leg make sure the support leg extension indicator
is green (8).
• Only after this has been done should the height of the support leg be adjusted.
• By holding down the leg height adjustment button (17), you will release the leg height lock
and the leg should automatically extend. Adjust the leg height so that the foot meets
resistance with the vehicle's ground; now you can release the button. If after the leg height
lock the foot indicator (10) turns green, it means that the installation is correct (fig. A.13)
otherwise repeat the adjustment of the support leg height.
ATTENTION! Never mount the foot of the support leg on the glove box on the floor of the
vehicle, there is a risk of the glove box collapsing during an accident, if in doubt consult the
vehicle handbook.
ATTENTION: The support leg must never hang in the air and no objects may be placed under
it.
IMPORTANT: Make sure the support leg is supporting and not raising the bottom of the
I- GUARD seat above the plane of the car seat.
• Take hold of the seat and check that it is securely fastened without slack. All ISOFIX
attachments and support leg indicators should display green. If not, repeat the previous
installation steps.
NOTE: Make sure the seat position is well established and stable. Check the indicators
on the ISOFIX attachment and the support leg.
47