Assembly Guide
Left Module (a)
Front Module
Left & Right Module
Connection Screws (S5)
06
Assembly Step 01:
1. Connect Stepper Motor Cables for each Y axis Arm- Left (a) and Right (b)
to Rear Module (Contains Mainboard, I/O Connections).
2. Remove the Rear Module Cover for cable management.
3. Align the two modules – Left (a) and Right (b) with 2 of the provided
Left & Right Module Connection Screws into the screw holes and tighten
them with the included 4mm hex wrench.
4. Repeat the steps above to assemble remaining frame modules. (X Axis
Module excluded).
Rear Module
Right Module (b)