Genmitsu Jinkosu LC-40 Benutzerhandbuch Seite 33

LaserGrbl & LightBurn Software Introduction
Step 3: Double click the window"Spd/Pwr",Set Laser Intensity (S value) and Travel Speed.
The Max power should be set to 10%-100%, depending on materials they will require different Speeds and
Percentage.Set the Power Scale to your lowest test power +10% to mimic what you want. make record and find
that Power & speed.
Step 4: Click "Start" to begin to engrave.
For more details you can refer to the document "LightBurnDocs".
Wear the glasses! Do not set them down like this with the laser on.
31