Receiving Measurements Automatically - Bresser Quadro Neo + 3 Sensors Bedienungsanleitung

14 Change room name
NOTICE! The room name cannot be changed when the time
signal search is active (the corresponding icon flashes). Wait
until the time signal search is completed to be able to
change the room name.
1.
2.
3.
4.
5.
6.

15 Receiving measurements automatically

Once batteries are installed, the base station will display the
measurement readings. Readings from the remote sensor
will be displayed within 3 minutes after powering it on.
16 Display change °C/°F
• Base unit
In normal display mode, press the DOWN button to toggle
between °C and °F.
• Wireless sensor
Open the battery compartment.
14 / 36
Press the ROOM button of the desired wireless sensor.
The room name flashes.
Press the ROOM button repeatedly to select one of the
5 preset room names. Alternatively, continue with 3. or
wait approx. 5 seconds until the change has been saved
automatically. The display stops flashing.
Press the UP button to switch to the entry of a free
room designation. "_" flashes.
Press the UP button until the desired input value
flashes. Possible input values: A-Z, 0-9, _ > < / * -
Press the ROOM button again to switch to the next in-
put value and enter it as described under 4.
Finally, press the ROOM button to save the entry. If no
entry is made within 5 seconds, the settings made up to
this point are automatically saved. In both cases the
display stops flashing and the free input is stored.