Before Commissioning - Bresser Quadro Neo + 3 Sensors Bedienungsanleitung

13 Symbol for enabled alarm
15 Radio clock signal reception
icon
17 Current date
19 Symbol for connection to
the wireless sensor

6 Before commissioning

NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices,
the following points must be observed during commission-
ing.
1. Place the base unit (receiver) and sensor (transmitter)
as close together as possible.
2. Connect the power supply to the base unit and wait un-
til the indoor temperature is displayed.
3. Establish power supply for the sensor.
4. Set up/operate the base unit and sensor within the ef-
fective transmission range.
5. Make sure that the base unit and the radio sensor are
set to the same channel.
When changing the batteries, always remove the batteries
from both the base unit and the sensor and reinsert them in
the correct order so that the radio link can be re-estab-
lished. If one of the two devices is operated via a mains
power connection, the power connection must also be
briefly disconnected for this device when the batteries are
changed. If, for example, only the batteries in the sensor
are replaced, the signal may subsequently not be received
at all or not be received correctly.
14 Symbol for active time zone
setting
16 Symbol for active daylight
saving time
18 Current day of the week
20 Channel of the radio sensor
9 / 36