Klarstein SAINT HELENS STUDIO LOFT 2 Bedienungsanleitung Seite 43

Using the remote control
Before using the remote control, make sure that the mains plug of the unit is plugged in
and that the mains switch is in the "ON" position.
Note: When using the remote control, make sure that you point the remote control at
the screen of the unit when pressing any of the buttons. A beep will sound. There may
be a slight delay in the signal transmission from the transmitter to the receiver. Do not
press the respective button more than once within 2 seconds during operation.
Function
On/off switch
Flame
Timer
Heating function
Description
Press this button to switch the device on or off. Press
this button once to turn the device and the flame
effects on. If you press this button again, the unit and
the flame effects are switched off and the unit is in
standby mode.
To activate the child lock, press and hold the button
for 10 seconds. As soon as the child lock is active,
the heating goes off but the flame effect remains on.
Four brightness levels can be selected (L1-L4).
Press the timer button to select one of the following
timer settings: 1 > 2 > 3 > 4 > 5 > 6 > 7 > 8 > 9 >
OFF > 1
Press this key several times to set the following
functions: Room temperature between 17 °C and
27 °C (62 °F - 82 °F) > Heating continuously ON
> Heating OFF.
To activate the child lock, press and hold the button
for 10 seconds. As soon as the child lock is active,
the heating goes off but the flame effect remains on.
To switch between Fahrenheit and Celsius, press
and hold the button for 5 seconds.
EN
43