Making Small Ice Cubes; Stop Making Ice Cubes - Silvercrest SEMK 105 B2 Bedienungsanleitung Und Sicherheitshiweise

SilverCrest SEMK 105 B2
•
Depending on the ambient temperature, ice cubes are dropped into the ice cube basket (14)
after 7 to 15 minutes.
•
You can remove the ice cubes at any time. Open the lid (1), remove the ice cubes you want
using the ice cube scoop (8) and close the lid (1) again.
•
When the "ICE FULL" LED (5) lights red, the ice cube basket (14) is full. Ice cube making is
paused. Once you have removed sufficient ice cubes, the device resumes production.
Occasionally, the ice cubes can stack up, block the light barrier and give an erroneous
signal that the ice cube basket (14) is full. If this happens, use the ice cube scoop (8) to
distribute the ice cubes evenly around the ice cube basket (14). Ice-making resumes
automatically once the light barrier is clear.
•
If the "ADD WATER" LED (4) lights red, there is too little water in the water reservoir (13). Ice
cube making is stopped.
•
Open the lid (1), remove the ice cube basket (14) and top the water reservoir (13) up with
fresh drinking water if you wish to continue making ice cubes.
•
Replace the ice cube basket (14), close the lid (1) and press the "POWER" button
to resume.

7.2.2 Making small ice cubes

•
If you press and hold the "POWER " button (6) for approx. 3 seconds while making large ice
cubes, the "ICE MAKING" LED (3) lights up in yellow. On its next cycle, the machine makes
small ice cubes.

7.3 Stop making ice cubes

Replace the water in the water reservoir (13) after 24 hours at the latest to prevent
mould forming.
•
Press the "POWER"
flashes green.
•
Remove the ice cubes from the ice cube basket (14) and disconnect the plug from the mains
socket.
•
Allow the ice cube maker to defrost.
•
Then check whether there is water in the back part of the machine. If so, tip the machine
forwards slightly so the water can flow into the water reservoir (13).
•
Now drain the water out of the water reservoir (13). Pull the device forward over the edge of
the work surface so that the drain opening (12) is easy to reach but the device is still stable.
•
Hold a suitably sized container under the drain opening (12) and remove the stopper.
•
Once all the water has drained out, close the drain opening (12) again with the stopper.
12 - English
button (6) briefly to stop making ice. The "ICE MAKING" LED (3)
(6) briefly