5. This is the setting interface of engraving times
Click "+/-" to set the number of times of
engraving. After setting, click the confirm button
to enter the engraving interface.
2
6、This is the interface during engraving. This interface can be
paused, stopped, and the power and speed can be adjusted. (Note:
There is no return button in this interface. You can only stop
working and return to the engraving preparation interface. After
the engraving is completed, it will return to the engraving
preparation interface. The head will move to the starting position
of the last engraving to facilitate repeated engraving of the unified
file.
1.Click the "+/-" button to adjust the power and speed, "1%,
10%, 20%" is the percentage value of the power and speed
adjustment, select a different percentage value, and click the "+/-"
button value Also different.
2.Click the pause button to pause the laser engraving operation.
1