Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S t e p 3
4
3
1
3
2
3
Synchronous belt *2
Step3 Required Components:
Step3 Required Components:
Installation Manual:
1. Install two synchronous belts as shown in the figure. First
tighten one end with a T-nut, then pass the other end through
the roller on the X-axis assembly as shown in the figure, and
finally tighten the other end and fix it with a T-nut.
2. T-nut fixing method (Push the T-nut from the groove on the
end of the profile, and then use the screw to tighten the T-nut),
the T-nut is as close to the end of the profile as possible, and
cut off the excess belt.
3. Cover the profile end cover (the side of the end cap with
protrusions is facing down)
TIPS:
The installation of the Y-axis synchronous belt can refer to the
installed synchronous belt on the X-axis assembly.Determine
whether the timing belt is tight enough: press the position
shown in Figure 4 with your fingers, and if there is no obvious
Tighten the T nut and cut
deformation, it is tight enough. If the deformation is large,
loosen one end of the T-nut and tighten the timing belt, and
off the excess belt.
then tighten the T-nut.
Profile end cover *3
Type T Nut *4
Type T Nut Lock
screws*4
Werbung
Inhaltsverzeichnis
