Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
3
3、This is the engraving file list interface, which
can perform file name selection, page up and
down, and return to the startup interface.
1. Click the back button to return to the boot
interface.
2. Select the corresponding file name to enter
the engraving preparation interface.
3. Click the left and right page buttons to turn
the file name up and down.
1
2
4
6
5
4、This is the engraving preparation interface, which can perform
engraving start, X/Y axis movement, center point, contour scanning,
and positioning operations.
1. Click the back button to return to the engraving file list interface
and the startup interface
2. Engraved file name display
3. Click the up, down, left and right arrow function buttons to
move the Y axis and X axis, click the arrow middle button to return to
the zero position of the X/Y axis, "0.1, 1, 10" are the X/Y axis travel
distance values, select different values The travel distance of X/Y axis is
also different. The maximum engraving range is "X: 250, Y: 220". The
coordinates will change with the movement of X/Y axis.
4. After clicking the engraving start button, the engraving times
can be set. The engraving machine executes the engraving action
5. Click the center point button to set the position of the laser
center point
6. Click the contour scan button, the laser can automatically walk
the engraving file size range (Note: when the engraving file nc or .gc
file is larger than 1M, the laser will automatically walk for a long time,
and it will take about 2-10 minutes).
7. After clicking the positioning button, click the confirm button to
locate the starting point of the laser
3
7
Werbung
Inhaltsverzeichnis
