Special Safety Instructions - Würth ESF 500-E Universal Originalbetriebsanleitung

Safety Warnings Common for Grind-
ing, Sanding, Wire Brushing, Polishing
or Abrasive Cutting-Off Operations:
Use
This power tool is designed to function
a)
as a grinder and as a polisher. Read all
safety warnings, instructions, illustra-
tions and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/
or serious injury.
Operations such as wire brushing or
b)
cutting-off are not recommended to be
performed with this power tool. Opera-
tions for which the power tool was not designed
may create a hazard and cause personal injury.
Do not use accessories which are not
c)
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power tool, it
does not assure safe operation.
The rated speed of the accessory must
d)
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can break
and fly apart.
The outside diameter and the thickness
e)
of your accessory must be within the
capacity rating of your power tool. In-
correctly sized accessories cannot be adequately
guarded or controlled.
Treaded mounting of accessories must
f)
match the grinder spindle thread. For
accessories mounted by flanges, the
arbour hole of the accessory must fit the
locating diameter of the flange. Acces-
sories that do not match the mounting hardware
of the power tool will run out of balance, vibrate
excessively and may cause loss of control.

Special Safety Instructions

g)
fore each use inspect the accessory such
as abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If a power tool or accessory is
dropped, inspect for damage or install
an undamaged accessory. After inspect-
ing and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load
speed for one minute. Damaged accessories
will normally break apart during this test time.
h)
Depending on application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hear-
ing protectors, gloves and workshop
apron capable of stopping small abra-
sive or workpiece fragments. The eye pro-
tection must be capable of stopping flying debris
generated by various operations. The dust mask
or respirator must be capable of filtering particles
generated by your operation. Prolonged exposure
to high intensity noise may cause hearing loss.
Keep bystanders a safe distance away
i)
from your work area. Anyone entering
the work area must wear personal pro-
tective equipment. Fragments of workpiece or
of a broken accessory may fly away and cause
injury beyond immediate area of operation.
Hold power tool by insulated gripping
j)
surfaces only, when performing an op-
eration where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
k)
accessory. If you lose control, the cord may be
cut or snagged and your hand or arm may be
pulled into the spinning accessory.
Never lay the power tool down until the
l)
accessory has come to a complete stop.
The spinning accessory may grab the surface and
pull the power tool out of your control.
Do not use a damaged accessory. Be-
Wear personal protective equipment.
Position the cord clear of the spinning
13