Assembly And Adjustments; Operation - DeWalt DCF680 Originalanweisungen

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the
battery pack. Always switch off the
tool before inserting or removing
the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
NOTE: Make sure your battery pack (f) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (f) with the recess inside
the tool's handle.
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (e) and firmly pull the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Battery Fuel Gauge (fi g. 1, 2)
The D WALT cordless screwdriver has a fuel gauge
E
(d) which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the
motion control activation trigger (a). A combination of
the three green LED lights will illuminate designating
the level of charge left. When the level of charge in
the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be
recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
Quick Release Chuck (Fig. 1, 4)
NOTE: The chuck accepts 6.35 mm hex
accessories only.
To install a bit, insert the bit into the chuck until the
clip locks it in place.
To remove a bit, pull the chuck collar (h) forward.
WALT battery
E
Remove the bit and release the collar.
Two Position Screwdriver (fi g. 3)
DCF680
To convert the tool to an angled screwdriver press
the release button ( j ) and rotate the top portion of
the tool as shown in figure 3.
Torque Adjustment Collar (fi g. 1, 3)
DCF680
The torque adjustment collar (i) is marked with
numbers and a MAX symbol. To set the torque
align the desired setting with the arrow on the tool
housing. The higher the number on the collar, the
higher the torque. To lock the clutch for heavy
fastening operations, move to the MAX position.
Failure to do this will allow the clutch to slip while
attempting to fasten.
Prior to Operation
• Make sure your battery pack is (fully) charged.
• Insert the appropriate bit.

OPERATION

Instructions for Use
Proper Hand Position (fi g. 5a-5c)
NOTICE: Do not use screwdriver as a
pry bar in either position.
CAUTION: To avoid screwdriver being
turned on accidentally, put the lock off
switch (b) in the up, locked-off, position.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
ENGLISH
35