Maintenance - eta Fenite Bedienungsanleitung

– Frequency of using the IMPORT mode: 2-3 times a week (persons with more sensitive skin 1-2 times a week)
– Duration of treatment in the IMPORT mode: 4 minutes (persons with more sensitive skin 1-2 minutes)
LIFTING
This mode is intended for smoothening of face contours and making them finer. It combines, heating, ionisation,
and EMS impulse therapy, providing effect on skin muscles and elastic collagen fibres.
Procedure (Fig. 5):
1. Apply the suitable jelly on application head A4.
2. Press A1 to switch on the appliance, select the LIFTING mode and take the appliance in your hand, touching
area A6 with your hand/fingers.
3. Where necessary and considering sensitivity of your skin use button A2 to adjust temperature and A3 to adjust
galvanisation intensity.
4. Treat your face as shown in Fig. 5, proceeding on individual parts of the face from the middle to the sides.
– Frequency of using the LIFTING mode: 1-2 times a week (persons with more sensitive skin once a week)
– Duration of treatment in the LIFTING mode: 4-8 minutes
EYE CARE
This mode is intended for skin care around the eyes. It combines heating, ionisation, vibrations and photon therapy
using red light and allows easy penetration of the face mask and other crèmes through the skin.
Procedure (Fig. 6):
1. Apply the beauty preparation onto the skin, around your eyes.
2. Press A1 to switch on the appliance, select the EYE CARE mode and take the appliance in your hand, touching
area A6 with your hand/fingers.
3. You can also switch on/off optional photon therapy using red light by brief pressing button A3, where necessary.
4. Make a fine massage of the face, around the eyes, as shown in Fig. 6.
– Frequency of using the EYE CARE mode: 2-3 times a week (persons with more sensitive skin 1-2 times a week)
– Duration of treatment in the EYE CARE mode: 4 minutes (persons with more sensitive skin 1-2 minutes)
COOL
This mode is intended for calming the skin. It combines cooling and photon therapy using blue light, which has
anti-inflammatory effect, and reduces skin redness, acne problems and also allows easy penetration of calming
preparations and rejuvenating face mask.
Procedure (Fig. 7):
1. Apply the required face mask.
2. Press A1 to switch on the appliance and select the COOL mode.
3. Smoothly press on sensitive and/or red spots, as shown in Fig. 7.
– Frequency of using the COOL mode: 2-3 times a week
– Duration of treatment in the COOL mode: 3 minutes (maximum 5 seconds at each spot)
Automatic switching off
In CLEANSING, IMPORT, LIFTING and EYE CARE modes, the selected function will be deactivated after approx.
4 minutes (sound signal). After another approx. 1 minute, the appliance will be switched off (sound signal).
In COOL mode, the selected function will be deactivated after approx. 3 minutes (sound signal). After another
approx. 1 minute, the appliance will be switched off (sound signal).
IV. MAINTENANCE
The appliance must be cleaned after every use! Use only soft cloth to wipe the surface of the appliance and the USB
cable. Storage D can be rinsed with flowing water. Do not use any abrasive or aggressive cleaning agents!
Recommendation
Recommendation
Doporučení
Recommendation
21 / 41
EN