eta Fenite Bedienungsanleitung Seite 20

EN
Battery level and charging state are displayed by indicator B6. The number of lighting segments increases
during the charging process. When the charging process has been completed, charging indicator will light
Optimise the battery service life
– Do not leave USB cable connected to the appliance.
– During charging or regular operation, the appliance heats up, which is
a normal phenomenon, and not a reason for a complaint.
CONTROL
In order to provide for proper galvanisation, area A6 must be touched with your hand/fingers. Consequently,
On/off button + setting operation modes (A1)
– By long pushing of button A1 (approx. for 2 sec.) you switch the appliance on/off. Upon switching on and off an
acoustic signal sounds.
– Press short A1 button to switch over the modes. – The operation mode you have set is shown on display B by
lighting up its name (CLEANSING / IMPORT / LIFTING / EYE CARE / COOL).
Temperature setting button (A2)
– Briefly press button A2 to adjust the temperature (3 heating levels are available). Set temperature is indicated by
individual segments on display B (next to symbol B4).
– The temperature can be adjusted in operation modes CLEANSING, IMPORT a LIFTING.
Galvanisation intensity button (A3)
– Briefly press button A3 to adjust galvanisation intensity (3 intensity levels). Set intensity level is visualised by
illumination of the relevant symbol B1 (L - low / M - medium / H - high) on display B.
– Galvanisation intensity can be adjusted in operation modes CLEANSING, IMPORT and LIFTING.
– In EYE CARE mode, the red light can be switched on/off by brief pressing button A3.
OPERATION MODES AND THEIR USE
CLEANSING
This mode is intended for efficient and deep skin cleansing. It combines positive ionisation, heating and vibrations
and allows removal of dead skin cells, sebum, impurities, traces of makeup and more.
Procedure (Fig. 3):
1. Place the cotton cloth on the application head A4 and apply the makeup remover (Fig. 2).
2. Press A1 to switch on the appliance, select the CLEANSING mode and take the appliance in your hand,
touching area A6 with your hand/fingers.
3. Where necessary and considering sensitivity of the skin, use button A2 to adjust temperature and button A3 to
adjust galvanisation intensity.
4. Make a fine massage of your face, as shown in Fig. 3.
– Frequency of using the CLEANSING mode: 2-3 times a week (persons with more sensitive skin 1-2 times a week)
– Duration of treatment in the CLEANSING mode: 4 minutes (persons with more sensitive skin 1-2 minutes)
IMPORT
This mode is intended for easier penetration of beauty preparations into deeper layers of the skin. It combines
negative ionisation, photon therapy using red light, heating and vibrations and allows efficient penetration of beauty
preparations, such as moisturising and rejuvenating crèmes, hyaluronic acid, oligopeptides etc. through the skin.
Procedure (Fig. 4):
1. Apply the beauty preparation onto the skin.
2. Press A1 to switch on the appliance, select the IMPORT mode and take the appliance in your hand, touching
area A6 with your hand/fingers.
3. Where necessary and considering sensitivity of the skin, use button A2 to adjust temperature and A3 to adjust
galvanisation intensity.
4. Treat your face as shown in Fig. 4. As soon as you feel resistance on the application head, the preparation has
been absorbed by the skin, and you can proceed on next part of your face.
continuously.
the appliance is intended exclusively for personal care.
Recommendation
Note
Note
20 / 41