Transportation, Storage And Disposal - Husqvarna BMG 444 Bedienungsanweisung

Error code
OSF
SCF1
SCF3
SCF5
SSF
PHF
USF
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product for shorter
distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
• Make sure that the product is in transport position
during transportation. Refer to
transport position on page 21 .
• Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a strong movement that is not possible
to brake by hand.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
1914 - 001 - 28.06.2022
Cause
The supply voltage is too high.
The mains supply s disturbed.
Short circuit or grounding at the output of the
product.
There is leakage of ground current at the
output if 2 or more motors are connected in
parallel.
There is a limitation in the switch to torque or
current.
Drive incorrectly supplied or a fuse blown.
One phase missing.
3-phase ATV320 used on a single-phase
supply mains.
Unbalanced load. This protection only oper-
ates with the drive on load.
The supply mains is too low.
There is a dip in the translate voltage.

Transportation, storage and disposal

Be careful during
To set the product in
Solution
Do a check of the supply voltage.
Do a check of the cables between the drive
to the motor.
Go to "DIAGNOSTICS" in the menu on the
keypad. Do the diagnostic test.
Reduce the switch frequency of the power
supply.
Connect chokes in series with the motor.
Do a check for any mechanical problems.
Do a check of the power connection and the
fuses.
Use a 3-phase supply mains.
Do a check of the voltage and the parame-
ters.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not stay
below or near the product.
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
Be very careful when you
For ramps with a steep
Do not move the product
19