Transportation, Storage And Disposal; To Set The Product In Transport Position - Husqvarna LC 141iV Bedienungsanweisung

Keypad
Error LED flashes
The product stops

To set the product in transport position

1. Remove the grass catcher (if installed).
2. Loosen the knobs on the upper handle and fold the
handle down. (Fig. 64)
3. Loosen the lower knobs.
4. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 65)
5. Fold the handle forward. (Fig. 66)
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
• Put tape on the battery connectors and make
sure that the battery cannot move around during
transport.
• Attach the product during transport.
Storage
• Always remove the batteries for storage.
• Let the product become cool before storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
• Keep the battery charger in a closed and dry space.
919 - 011 - 16.08.2023
Possible faults
The motor is overloaded
The motor speed drops too much,
and the motor stops
The motor control is too hot
The blade is blocked
Battery error or no signal from battery Put the battery in the product correctly and exam-
The battery is weak
Battery connector failure

Transportation, storage and disposal

Possible action
Increase the cutting height. See
height on page 20 .
Stop the motor and wait until it has become cool
To prevent accidental start turn the safety key to
0, remove the battery and wait a minimum 5 sec-
onds. Make sure that the blade can rotate freely.
If the problem continues, speak to an authorised
service agent
ine the battery connector. If the error LED on the
battery flashes, see
Charge the battery. See
page 20 .
Examine the battery connector
• Keep the battery and the battery charger in a dry
space where there is no moisture or frost.
• Disconnect the battery from the battery charger
during storage.
• Do not keep the battery where static electricity can
occur. Do not keep the battery in a metal box.
• Keep the product where the ambient temperature is
between -10°C and 40°C.
• Keep the battery where the temperature is between
5°C and 25°C and out of sunlight.
• Keep the battery charger where the temperature is
between 5°C and 45°C and out of sunlight.
• Make sure that the battery is charged to 30% - 50%
before you put it in storage for long periods.
• Keep the product, battery and battery charger in
a locked area out of reach for children and not
approved persons.
• Clean the product and do a complete servicing
before you put the product in storage for a long time.
• Do the maintenance procedures given in this
operator's manual. Refer to
22 .
• Do a complete servicing before long time storage.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
To set the cutting
Battery on page 24 .
To charge the battery on
Maintenance on page
25