Husqvarna BMG 444 Bedienungsanweisung Seite 12

extractor must be connected to a power
source suitable for both products.
To adjust the height of the handle and
handlebar
WARNING:
the the handlebar. Make sure that the
handlebar locks into position. The moving
parts can cause injury.
During operation set the handlebar height as close
as possible to the height of the operators hip. During
operation the product can pull to the side. The hip of the
operator can help to stop this movement to the side.
1. Pull the lock lever in the direction of the handlebar
and hold it in this position.
2. Adjust the handlebar to an applicable operation
height.
3. Release the lock lever to lock the handlebar position.
12
Be careful when you adjust
4. Pull the lock lever to release the handle and hold it in
this position (A).
5. Adjust the handle to an applicable operation (B).
6. Release the lock lever to lock the handle position.
To change the position of the wheels
The wheels can have 2 positions in the frame. The top
hole (A) is used during standard grinding and polishing
operation. The lowest hole (B) is used for bush hammer
tools.
1. Remove the bolts, the washers and the wheel from
the frame.
2. Install in the opposite sequence in the correct hole in
the frame.
A
B
1914 - 001 - 28.06.2022
A
B