General product maintenance
Make sure that the dust hoses are not damaged and free of
blockage.
Make sure that the dust collector is empty and connected correct-
ly.
Do a check of the buffer rubbers for damages and wear.
Do a check of the stop button.
Do a check of the brush strip.
Make sure that the power cord and extension cable are in good
condition and not damaged.
Do a check of the RCD.
Do a check of the cylinder rubbers of the diamond plates.
Clean the product with a moist cloth.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
•
After wet grinding, clean the brush strip with water.
Make sure that the remaining mixture of dust and
water is fully removed.
WARNING:
to clean below the grinding head.
Drive system for grinding head
The drive system for the grinding head is a closed
system. If you have problems with the drive system
of the grinding head, speak to your Husqvarna service
agent.
To do a check of the brush strip
•
Make sure that the brush strip is not damaged and
that it seals tightly against the floor.
To do a check of the cylinder rubbers
1. Do a check if the diamond plates have too much
movement in the cylinder rubbers.
1914 - 001 - 28.06.2022
Do not use compressed air
Daily
*
*
*
X
X
*
*
2. If there is too much movement, tighten the bolt (A) or
replace the cylinder rubbers (B).
3. Install 2 cylinder rubbers to have a more rigid
grinding head. Refer to the service manual more
information.
To reset the product
1. Disconnect the power plug.
2. Wait 5 minutes.
3. Start the product, refer to
control panel without speed adjustment on page 13 .
Note:
If the product does not start, speak to an
approved service agent.
Each 3
Weekly
months
X
B
A
To start the product,
*
15