Battery Charger; Control Panel; Transportation, Storage And Disposal; To Set The Product In Transport Position (Lc 551Iv) - Husqvarna LB 548i Bedienungsanweisung

Battery charger

LED on the battery
charger
The error LED flash-
es.
The error LED is on.

Control panel

Error code (Number
of flashes)
1
5
8
9
10
Other errors
Introduction
WARNING:
start during transport pull up the safety
key, remove the battery and wait at least 5
seconds.
To set the product in transport position
(LC 551iV)
1. Loosen the lower knobs.
28
Cause
The temperature in the work en-
vironment is too high or too low.
Possible faults
The transmission motor is too hot.
The motor speed decreases too much, and
the motor stops.
The battery is weak.
Battery error or no signal from battery.
The motor control is too hot.
If other errors occur, remove the safety key and the battery and speak to an approved
service agent.

Transportation, storage and disposal

To prevent unintentional
Solution
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent.
Possible procedure
Let the product become cool. Make sure that
the transmission does not have grass on it.
Clean the transmission cover if it is necessa-
ry.
Clean the cutting deck and increase the cut-
ting height. Refer to
(LB 548i, LC 551iV) on page 20 . If the error
stays, speak to your approved service agent.
Charge the battery. Refer to
battery on page 21 .
Put the battery in the product correctly and
examine the battery connector. If the error
LED on the battery flashes, refer to
on page 20 .
Stop the motor and wait until it is cool.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
To set the cutting height
To charge the
Battery
1630 - 004 -