Language; Factory Setting; Software Update; Setup Wizard - Kenwood CR-ST700SCD Bedienungsanleitung

19. Language

In the "Language" menu you can set the menu language of the radio. If you have started up
the device with the setup wizard, the device language has already been set there. To select a
language, please use the <UP> or <DOWN> buttons and confirm this by pressing the <OK> button.
Alternatively, the selection can also be made with the <NAVIGATE> knob.
The following languages are available:
Danish, German, English, Finnish, French, Italian, Dutch, Norwegian, Polish, Portuguese, Swedish,
Spanish, Turkish

20. Factory setting

To reset the radio to the delivery state, please select "YES" in the menu "Factory reset".
Attention: All previous settings are deleted.
If you select "NO" the process is cancelled.
Note: Be sure to reset the radio to the factory settings before you pass it on (e.g. to sell, give away or
dispose of).

21. Software update

In this menu you can check whether a software update is available for the radio.
If you select "Auto-check setting" the radio automatically checks the availability of new software
updates on a regular basis.
Select the menu item "Check now" to search for a new version. If newer software is found, please
select "YES" to install it or "NO" to cancel the update. If "YES" the radio restarts to carry out the
process.
Then the software is downloaded and you are asked with "Proceed" whether the update should be
carried out. Please choose "YES" if you consent or "NO" to cancel the update. The"Warning: do
not remove power" and the software version to be installed flash alternatively. When the process
is complete, "Update completed" appears on the display and you can confirm the process with the
<OK> button.
You can check the version number of the installed software under the "System settings" menu
under "Info".
Attention!
Make sure that there is a stable power supply before you start a software update.
An interruption during an update can cause irreparable damage to the radio!

22. Setup wizard

You can start the setup wizard again in the "Setup wizard" menu. To do this, proceed as described
under "3.8 Starting the setup wizard".
23. Info
In this menu you will find the version number of the current firmware, among other things. Have this
ready if you want to contact customer service.
25