Kenwood CR-ST700SCD Bedienungsanleitung Seite 41

Backside
1
1 - Bass Reflex Opening
4 - Headphone port
3.3 Switching On / Off (standby)
Press the <Standby> button on the remote control or on the device to switch on the radio.
Press the button again to put the device into standby mode. To switch it off completely, disconnect it
from the power supply.
3.4 Navigate in the menus
You can navigate through the menus by pressing the <Up/Down/Left/Right> buttons on the remote
control. Pressing once on the <OK> button confirms the selection. These operating steps can also be
carried out on the device using the <NAVIGATE> knob. Turn the knob to navigate through the menus,
confirm a menu item by pressing the knob.
3.5 Entering passwords, search texts, etc.
Use the <Up/Down/Left/Right> to select the corresponding numbers and/or letters individually and
confirm the selection by pressing <OK>. To correct an incorrect entry, please go to the <BKSP> field
and confirm with the <OK> button on the remote control. This will delete the last entry. Use the
"CANCEL" field to cancel the entry completely. If your selection is complete, please navigate to the
"OK" field and confirm the selection by pressing the <OK> button. The <INFO> button acts as a
hotkey to swap between the numbers/letters and <BKSP>.
3.6 Adjusting volume and "Mute"
You can adjust the volume by pressing the <Louder> and <Softer> buttons on the remote control or
by turning the <VOLUME> knob on the device. Pressing the <Mute> button mutes the radio. Another
pressing of the button restores the original volume.
2 3 4 5
2 - Telescop antenna
5 - USB port
6
3 - Aux input
6 - Power supply connector
9