Scheppach ox t500 Original Anleitungen Seite 11

2.5 mm².
16 A.
should be loosened by some rotations until air can go in
and out of the oil tank smoothly. Failed to loosen the bleed
screw will keep the sealed air in hydraulic system being
compressed after being decompressed. Such continuous
hydraulic system and cause permanent damage to your
scheppach machine.
bleed screw is tightened to avoid oil leaking from this
point.
Only split plain cut log.
2. Fix the log pusher in the required position according to
the length of the log.
Position 1: Length up to 52 cm,
Position 3: Length up to 42 cm.
draulic log splitter features two-handed control.
To start the splitting process, you must simultaneously
ately stop the splitting process, releasing both control
elements will abort the splitting process.
position.
log will not be split.
Important: Abort the process within 5 sec to avoid over-
loading.
In most cases the log can easily be split after rotating it
Therefore make sure that you insert the log with the
knots on the side of the pressure plate. This way the
splitting blade can penetrate the log more easily.
Wrongly placed log (Fig. 4)
Always set logs firmly on the log retaining plates and work
table. Make sure logs will not twist, rock or slip while being
split. Do not force the blade by splitting logs on the upper
part. This will break the blade or damage the machine.
Do not attempt to split 2 pieces of logs at the same time.
One of them may fly up and hit you.
Jammed log (Fig. 5)
will damage the machine or may launch the log and cause
accident.
2. After the log pusher moves back and completely stops
at its starting position, insert a wedge wood under the
jammed log as shown in fig. 5.
2. Start the log splitter to push the wedge wood under the
jammed one.
ox t500 Innen.indd 9
Operation
scheppach machine, the bleed screw
scheppach machine, make sure the
until the log is completely freed.
Back-run safety device
wood.
To install the stop move the pressure plate towards the
splitting wedge.
Once the final position is achieved only hold down the hy-
draulic lever with the lever locking to avoid a return move-
ment of the pressure plate.
ing surface of the tube.
Adjustment of the pressure plate
Lift the pin on the left of the pressure plate and pull out
the pressure plate. Then, reinsert the pin.
Pos. Max. distance to the splitting wedge approxi-
The device must not be operated if the pressure plate is
not properly secured.
Oil Change (Fig. 3.1, 3.2)
-
The hydraulic system is a closed system with oil tank, oil
pump and control valve.
tightness. Tighten when necessary.
-
Replacing hydraulic oil after 150 hours of use (Fig. 3)
1. Make sure all moving parts stop and the log splitter is
unplugged.
3. Turn the log splitter on the support leg side as shown
in fig. 3.1 over a 4 liter capacity container to drain the
hydraulic oil off.
4. Turn your scheppach machine on the motor side as
shown in fig. 3.2 to refill about 2,4 l fresh oil.
and put it back into the oil tank while keeping the log
splitter vertically. Make sure the level of the refilled oil is
just between 2 grooves around the dip stick.
sure it is tightened to avoid leakage before placing the
log splitter horizontally. Afterwards start splitting with-
out actually splitting log several times.
-
-
-
-
english 9
15.09.11 12:45